# ============================================================================= # run_xedebug.tcl -- Run the demo on Palladium Z2 (SA mode) from xeDebug. # # Launch (ON THE SA HOST, from the ixcom_db directory made by compile_sa.sh): # xeDebug -f run_xedebug.tcl # or start xeDebug interactively and `source run_xedebug.tcl`. # # SA-mode notes: # * xeDebug MUST run on the SA host (not on an arbitrary workstation). # * There is no separate xmsim log in SA mode: simulator output is merged # into xeDebug.log -- grep it for "CHECK" / "TEST PASSED" / *E,*F errors. # * Command spellings (host / xc on -run) follow the Z2 guide and field # practice; confirm with xeDebug `help` on your VXE release if needed. # ============================================================================= # 1) Connect to the emulation host (same value as $XE_HOST). # Use `host .` instead if xeDebug is already running on that host. host # 2) Download the design into the emulator and start it (hot-swap download). xc on -run # 3) The testbench (host side) now drives the APB bus, waits for the timer # interrupt, and prints its checks. A successful run ends with: # CHECK OK : ID register = 0x5a320001 # ... (8 checks) ... # TEST PASSED (all checks) # Watch xeDebug.log, or in the GUI open the waveform on: # tb_z2_demo.dut.reg_count / gpio_out / irq # # If the run appears stuck, do NOT kill it blindly: first check whether # xc_top.simTime is still advancing and take two gstack samples of the # xmsim main thread (a spinning main thread points to a zero-time loop # in the TB, a blocked one points elsewhere). # 4) Optional: keep the host connection warm for the next xeDebug session # (default reuse window is 180 s): # xeset keepHostAliveTimeout 600