// ----------------------------------------------------------------------------- // tb_z2_demo_ice.v -- Local-only bench for the ICE top. // In real ICE mode there is no testbench at all: clk/rst come from the target // or emulator clock setup and the result is the PASS/FAIL LEDs. This bench // only supplies clock/reset locally and watches the LEDs, so the stimulus // FSM itself can be verified before an ICE compile. // ----------------------------------------------------------------------------- `timescale 1ns/1ps module tb_z2_demo_ice; reg clk; reg rst_n; wire [7:0] led_gpio; wire led_irq; wire led_done; wire led_pass; wire led_fail; integer cycles; integer errors; z2_demo_ice_top top ( .clk_in (clk), .rst_n_in (rst_n), .led_gpio (led_gpio), .led_irq (led_irq), .led_done (led_done), .led_pass (led_pass), .led_fail (led_fail) ); initial clk = 1'b0; always #5 clk = ~clk; initial begin $dumpfile("ice/sim_local/z2_demo_ice.vcd"); $dumpvars(0, tb_z2_demo_ice); errors = 0; rst_n = 1'b0; repeat (4) @(negedge clk); rst_n = 1'b1; // wait for the hardware sequence to finish (guard: 1000 cycles) cycles = 0; while (!led_done && cycles < 1000) begin @(negedge clk); cycles = cycles + 1; end if (!led_done) begin $display("CHECK FAIL : ICE sequence did not finish in 1000 cycles"); errors = errors + 1; end else begin $display("CHECK OK : ICE sequence finished in %0d cycles", cycles); end if (led_pass && !led_fail) $display("CHECK OK : led_pass=1 led_fail=0"); else begin $display("CHECK FAIL : led_pass=%b led_fail=%b", led_pass, led_fail); errors = errors + 1; end if (led_gpio === 8'h02) $display("CHECK OK : led_gpio pattern = 0x02 (rotated once)"); else begin $display("CHECK FAIL : led_gpio = 0x%02h, expected 0x02", led_gpio); errors = errors + 1; end if (errors == 0) $display("ICE LOCAL TEST PASSED"); else $display("ICE LOCAL TEST FAILED (%0d)", errors); $finish; end endmodule