#!/bin/sh # ============================================================================= # compile_sa.sh -- IXCOM compile for Palladium Z2, SA (Simulation Acceleration) # # . ./scripts/env_z2.sh # XE_HOST / XE_BOARDS must be set first # ./scripts/compile_sa.sh # # What IXCOM does here: # -ua unified acceleration compile (design + testbench) # +dut+z2_demo_top the DUT partition that is mapped into the emulator; # everything else (the TB) stays on the host simulator # The compile runs inside ./ixcom_db (AxisWork and the design database land # there) -- run xeDebug from that directory afterwards. # # FIX (2026-10-19): the file lists rtl.f/tb.f contain paths relative to the # PACKAGE ROOT, but vlan resolves them against the compile working directory # (ixcom_db/), which produced: # Error! [FILE_OPEN_ERR] Could not open file (rtl/z2_demo_top.v) # This script therefore generates ABSOLUTE-path file lists for the compile. # It also checks the ixcom exit status / log explicitly, because piping to # tee would otherwise mask a failed compile behind a "finished" message. # ============================================================================= set -e cd "$(dirname "$0")/.." ROOT="$PWD" : "${XE_HOST:?set XE_HOST first: . ./scripts/env_z2.sh}" : "${XE_BOARDS:?set XE_BOARDS first: . ./scripts/env_z2.sh}" mkdir -p ixcom_db # Build absolute-path file lists (relative entries are prefixed with $ROOT; # entries that are already absolute, blank lines and comments pass through). for f in rtl tb; do out="ixcom_db/${f}_abs.f" : > "$out" while IFS= read -r line || [ -n "$line" ]; do case "$line" in /*) echo "$line" >> "$out" ;; ""|\#*) [ -n "$line" ] && echo "$line" >> "$out" ;; *) echo "$ROOT/$line" >> "$out" ;; esac done < "${f}.f" done cd ixcom_db set +e ixcom -ua +dut+z2_demo_top \ -f ./rtl_abs.f -f ./tb_abs.f \ > compile_sa.log 2>&1 rc=$? set -e cat compile_sa.log if [ "$rc" -ne 0 ] || grep -q "FLOW_FAILED" compile_sa.log; then echo "== IXCOM compile FAILED (rc=$rc) -- see ixcom_db/compile_sa.log ==" exit 1 fi echo "== IXCOM compile finished OK, log: ixcom_db/compile_sa.log =="